コレクション: HSS Ball Nose End Mills
HSS ball nose end mills cut a radiused profile — used for 3D contouring, fillet milling and finishing curved surfaces where a square corner would leave a step.
Flute count
2 flute — more chip room, better for aluminum and deep cuts where evacuation matters.
4 flute — more edges in the cut, better surface finish and feed rate on steel.
Using a ball nose
The effective cutting speed at the tip is near zero, so the centre of the ball rubs rather than cuts. Keep the stepover to about 10-15% of the ball diameter for a clean finish, and avoid plunging straight down — ramp in instead.
-
4-Flute HSS Ball Nose End Mill | R4–R16 | BB Tool
通常価格 $6.70 USDから通常価格$0.00 USDセール価格 $6.70 USDから -
HSS Ball Nose End Mills | 2 & 4 Flute, R0.5–R16 | BB Tool
通常価格 $3.20 USDから通常価格$0.00 USDセール価格 $3.20 USDから