Carbide Circular Slitting Saw for Metal | 70–100mm

Carbide Circular Slitting Saw

A compatible saw arbor/toolholder is required and is not included in this listing. Confirm bore size and holder compatibility before ordering.

☆Material:

Solid-carbide construction provides rigidity, wear resistance and heat resistance for precision slotting and cut-off applications.

Ground blade faces and controlled geometry support stable cutting when runout, clamping and coolant are properly controlled.

☆Processing:

Precision：
Inner hole——+0.01~0.02
Outer——±0.02

☆Sawing:

Precision-ground teeth are designed for smooth slotting when the saw is mounted accurately and operated within suitable cutting conditions.

The thinner the saw blade is, the more sensitive it is to vibration and tensile stress when using it. If there is radial runout or axial runout, it is easy to cause damage.
Thin saw blades are sensitive to radial and axial runout. Use a rigid machine, stable arbor and consistent coolant supply. The specific requirements are as follows:
1. The accuracy of the milling cutter installed on the cutter Rod shall generally meet the following requirements: radial runout <0.02mm, axial runout ≤ 0.01mm.
2. As long as the milling depth of the milling cutter is not affected, clamp the two sides of the blade on the cutter rod with a large flange plate as much as possible, in order to eliminate vibration and avoid lateral compression. Generally, the diameter of the flange plate is not less than 1/3 of the outer diameter of the saw blade.
3. Reasonable milling linear speed Vc and feed rate Sz per tooth should be selected. Generally, under the same conditions, the whole hard alloy saw blade milling cutter can choose Vc faster than the high-speed steel saw blade milling cutter, but the feed rate per tooth should be lower than the feed rate of high-speed steel. Sz can generally be set between 0.005-0.025/tooth. The specific parameters should be determined by the user according to the speed of milling machine, the properties of the milling, thickness, number of teeth, milling depth and other factors are determined.

Vc:
P: 70~150, 50~80
K: 80~120
M:70~120
N:200~350
S:20~50

Outer Diameter——Cutting Depth
40mm——3mm
50mm—— 5mm
63mm——8mm
70mm——10mm
75mm——12mm
80mm——15mm
100mm——20mm
125mm——30mm