BB Tool

JIN Carbide Drill | Titanium & Superalloy | Through Shank

JIN Carbide Drill | Titanium & Superalloy | Through Shank

通常価格 $11.50 USD
通常価格 セール価格 $11.50 USD
セール 売り切れ
配送料はチェックアウト時に計算されます。
Diameter
数量

JIN Carbide Drill for Titanium & Superalloy — Through Shank

The through-shank version of the JIN series, for titanium, Inconel and other high-temperature alloys in everyday plate work. For deep holes and stacked plates, see the long series.

Why the geometry suits superalloys

Nickel-based alloys work-harden faster than steel. A sharp, narrow point reduces the rubbing at entry that hardens the surface ahead of the edge, and the coated flute stops the chip welding to the rake face under heat.

Materials

  • Titanium alloys — pure Ti, Ti-6Al-4V
  • High-temperature alloys — Inconel 718 / 625, Hastelloy, Nimonic
  • Stainless steel, duplex and precipitation-hardening grades
  • Hardened steel up to 55 HRC

Reading the size

3.0x25x50 means 3.0 mm diameter, 25 mm flute, 50 mm overall. Long series carry an L after the size.

Running it

Low surface speed, high feed, no dwell. On Inconel keep the coolant on the cutting edge, not the shank, and retract fully on pecks so the chip clears instead of being re-cut and work-hardening the hole.

詳細を表示する