Collection: Insertion PCD

PCD (polycrystalline diamond) turning inserts for non-ferrous and non-metallic work. The diamond edge stays sharp far longer than carbide in abrasive materials, and runs at much higher cutting speeds.

Where PCD wins

Aluminum and aluminum alloys, copper and brass, carbon fiber and glass fiber composites, graphite, and hard plastics. Also used on tungsten carbide and ceramics where nothing else holds an edge.

Where it does not

Steel and iron. Carbon diffuses into the diamond at the temperatures those materials generate, and the edge fails quickly. Use CBN or coated carbide instead.

Handling

The diamond layer is brittle. Avoid interrupted cuts and impact, and never use a diamond wheel to touch up the edge without the right grade.