Collection: Fraise à ébaucher HSS
Roughing end mills carry a serrated edge that breaks chips into short segments, so the tool removes material fast without packing the flutes. Use one to clear bulk stock, then switch to a finishing end mill for the final pass.
Coarse vs fine pitch
Coarse pitch — larger teeth, deeper cuts, best on mild steel and aluminum where chip load is high.
Fine pitch — smaller teeth, smoother cut, better on stainless and harder steels where a coarse tooth would chatter.
Trade-off
A roughing mill leaves a scalloped surface — typically 0.1 to 0.3 mm of stock for the finisher. Leave enough material that the finishing pass cuts under the scallops rather than skimming them.
-
PromotionFraise d'ébauche BB HSS
Prix habituel À partir de $2.63 USDPrix habituel$3.42 USDPrix promotionnel À partir de $2.63 USDPromotion -
PromotionFraise d'ébauche BB HSS
Prix habituel À partir de $5.63 USDPrix habituel$7.32 USDPrix promotionnel À partir de $5.63 USDPromotion -
4-Flute HSS Roughing End Mill | 5–45mm
Prix habituel À partir de $3.70 USDPrix habituel$0.00 USDPrix promotionnel À partir de $3.70 USD