Коллекция: Скругление углов
Corner rounding end mills cut a concave radius along an internal edge, leaving a smooth fillet instead of a sharp corner. Used on moulds, dies and any part where an inside corner needs a defined radius.
Two types
Standard 55° radius cutter — single-end, radius ground on the tip. Covers R0.2 to R10 in shank diameters from 4 mm to 25 mm, with 50, 60, 75, 80, 100 and 150 mm overall lengths.
60° double-end radius cutter — radius on both ends of the cutting head, so the same tool cuts the top and bottom edge of a slot in one setup. R0.2 to R3.
Grades
BF2055 for aluminum and non-ferrous, BB2055 for steel and stainless steel. BC2055 and BK2055 are available on the double-end type for harder workpiece materials.
How to specify
Give the radius (R value), the shank diameter and the overall length. The R value has to match the fillet on the drawing: an R1 cutter does not produce an R1 fillet if the corner carries a different included angle.
-
Фреза для скругления углов BB -BF2055 BB2055
Обычная цена От $11.25 USDОбычная цена$0.00 USDЦена со скидкой От $11.25 USD -
Corner Rounding Carbide Cutter | R0.2–R3 | BF2055 & BC2055
Обычная цена От $15.34 USDОбычная цена$0.00 USDЦена со скидкой От $15.34 USD