Коллекция: Черновая концевая фреза-HSS
Roughing end mills carry a serrated edge that breaks chips into short segments, so the tool removes material fast without packing the flutes. Use one to clear bulk stock, then switch to a finishing end mill for the final pass.
Coarse vs fine pitch
Coarse pitch — larger teeth, deeper cuts, best on mild steel and aluminum where chip load is high.
Fine pitch — smaller teeth, smoother cut, better on stainless and harder steels where a coarse tooth would chatter.
Trade-off
A roughing mill leaves a scalloped surface — typically 0.1 to 0.3 mm of stock for the finisher. Leave enough material that the finishing pass cuts under the scallops rather than skimming them.
-
РаспродажаКонцевая фреза BB для черновой обработки HSS
Обычная цена От $2.63 USDОбычная цена$3.42 USDЦена со скидкой От $2.63 USDРаспродажа -
РаспродажаКонцевая фреза BB для черновой обработки HSS
Обычная цена От $5.63 USDОбычная цена$7.32 USDЦена со скидкой От $5.63 USDРаспродажа -
4-Flute HSS Roughing End Mill | 5–45mm
Обычная цена От $3.70 USDОбычная цена$0.00 USDЦена со скидкой От $3.70 USD