Collection: Fraise à queue conique
Tapered end mills cut angled walls, dovetail slots and draft angles in one pass. This page lists both grades together so you can compare before choosing.
Carbide or HSS
Solid carbide (BF2055) — stays sharp at high cutting speed, holds tolerance on long runs, and handles abrasive aluminum alloys. The right choice for CNC production.
HSS (M2) — sharper edge, more forgiving on older or less rigid machines, lower cost per tool. Wears faster at speed, so run it slower than carbide.
Reading the taper
The taper is ground per side. A 5° cutter widens 10° across the flutes, which matters when you are matching a dovetail or a draft angle on a drawing. Check whether the drawing quotes the included angle or the per-side angle before ordering.
Browse by material
- Carbide tapered end mills — BF2055, for aluminum and non-ferrous
- HSS tapered end mills — M2, for general steel work
-
Fraise conique BB -BF2055
Prix habituel À partir de $14.00 USDPrix habituel$0.00 USDPrix promotionnel À partir de $14.00 USD -
HSS Tapered End Mill | 0.5°–15° Taper | 2–12mm
Prix habituel À partir de $6.00 USDPrix habituel$0.00 USDPrix promotionnel À partir de $6.00 USD