Перейти к информации о продукте
1 из 1

BB Tool

HSS Step Drill & Countersink | Dual Cutting | M2–M14 | 90° / 180°

HSS Step Drill & Countersink | Dual Cutting | M2–M14 | 90° / 180°

Обычная цена $6.90 USD
Обычная цена Цена со скидкой $6.90 USD
Распродажа Продано
Стоимость доставки рассчитывается при оформлении заказа.
Finish
Size
Количество

HSS Step Drill & Countersink — Dual Cutting, M2 to M14

A high-speed steel step drill that cuts two ways: the 90° or 180° head deburrs and countersinks, while the stepped body opens a hole to the next size up in one pass. Made for M2 to M14 metric fasteners, in sheet metal, plate and tube.

Dual cutting geometry

The head cuts a countersink while the steps enlarge the hole. One tool replaces a drill plus a countersink, and the step depth stops the cut at the right diameter — no measuring, no overshoot on thin sheet.

90° or 180°

  • 90° — standard metric countersink angle for flat-head screws, and the usual choice for deburring both sides of a hole.
  • 180° — shallow, near-flat chamfer for flush rivets and thin sheet where a 90° cone would cut too deep.

Finish

  • TiN — gold titanium nitride, general purpose, longer life on steel and stainless.
  • Black Oxide — lower cost, holds coolant, suits aluminium and non-ferrous where coating build-up is not wanted.
  • Gold TiN — the small M2 sizes in the TiN coating.

Reading the size

M6 - 90° means the tool steps up to an M6 fastener and the head cuts a 90° countersink. The M number is the thread size it prepares, not the drill diameter.

Where it is used

  • Sheet metal and plate up to 4 mm
  • Countersinking and deburring in one operation
  • Control panels, enclosures, brackets
  • Site work where one tool must do several sizes
Просмотреть всю информацию