BB Tool

JIN Carbide Drill | Titanium & Superalloy | 100mm Long Series

JIN Carbide Drill | Titanium & Superalloy | 100mm Long Series

Обычная цена $166.00 USD
Обычная цена Цена со скидкой $166.00 USD
Распродажа Продано
Стоимость доставки рассчитывается при оформлении заказа.
Diameter
Количество

JIN Carbide Drill for Titanium & Superalloy — 100mm Long Series

The 100 mm overall JIN drill for deep holes in titanium, Inconel and stacked plate where a standard drill cannot reach the bottom.

Why long series on superalloys

Deep holes in nickel alloys are where a drill fails most often: the chip packs, the edge rubs, and the hole work-hardens below the surface. The longer flute needs a faster retract and a firm coolant stream, which is why these are specified separately from the standard range.

Materials

  • Titanium alloys — pure Ti, Ti-6Al-4V
  • High-temperature alloys — Inconel 718 / 625, Hastelloy, Nimonic
  • Stainless steel, duplex grades

Reading the size

3.0x50x100L means 3.0 mm diameter, 50 mm flute, 100 mm overall, long series.

Running a long drill

More length means more deflection. Reduce feed at entry, use a pilot hole where possible, and keep coolant on the tip — the extra reach gives chips more room to pack the flute.

Просмотреть всю информацию